Installing on Debian and Ubuntu

Riak TS can be installed on Debian or Ubuntu-based systems using a binary package available here.

Dependencies

ulimit

Debian and Ubuntu give you a very small limit on open file handles. Even with a backend that uses very few file handles, it’s possible to run out. See Open Files Limit for more information about changing the limit.

PAM Library Requirement for Ubuntu

You must have the libpam0g-dev package used for Pluggable Authentication Module (PAM) authentication in order to install Riak TS.

To install this dependency:

sudo apt-get install libpam0g-dev

Install Riak TS

Once you have downloaded the package, execute the following command to install Riak TS:

sudo dpkg -i riak-ts_1.5.0-1_amd64.deb

Verify your installation

You can verify that Riak TS is successfully installed by running:

dpkg -l | grep riak

If Riak TS has been installed successfully riak-ts is returned.

Start your Riak TS node

Once you’ve installed Riak TS, start it on your node:

riak start

Verify Riak TS is running

You can verify that Riak TS is started and ready to use by pinging it.

riak ping

If Riak TS has started, you will receive a pong response. If it has not started, you will receive an error.

Next Steps

Now that you’ve installed Riak TS, check out Planning Your Riak TS Table.